The tattoo removal device uses the explosive effect of a laser to effectively penetrate the epidermis and achieve the pigment group in the dermis. Since the laser action time is extremely short (just a few nanoseconds), and the energy is extremely high, the pigment group quickly expands after the absorption of the high -energy laser in an instant and decays into small particles. These small particles are absorbed by macrophages in the body and excreted from the body. The pigment gradually fades and disappears, and ultimately reaches the purpose of treatment.
Wavelength 1064 nm
Removing freckles, traumatic pigmentation, tattoos, eyebrow tattoos, eyes for the eyes and other black and blue pigments
Wavelength 532 nm
Removing small coffee spots, tattoos, eyebrow tattoos, eyes for the eyes and other red and brown pigment lesions
Wavelength 1320 nm
Decoration of the skin of a doll with a black face
Wavelength 755 nm
Pigment removal
Machine for removing tattoos Principle:
Use a laser with a wavelength of 755 and an instant lens with a cellular structure to focus 70% of the laser energy, destroy melanocytes in the epidermis, stimulate a network of collagen fibers, promote the renewal and proliferation of collagen and elastic fibers, accelerate the metabolism of the skin, and accelerate metabolism and excretion of melanin.
1320 nm carbon piling lens
Carbon laser peeling is a revolutionary laser procedure that is absolutely painless.
It is very useful for people with any of the following skin problems:
Bold skin
Black dots
Extended pores
Dull skin
Eying on the face and body
This is also a great way to exfoliate and refresh the skin, providing instant fresh appearance, making the skin softer, smooth and elastic.
Equipment cleaning:
Use a soft towel to clean the outer surface of the machine at least once a week. You can use a neutral detergent, but be careful so that the liquid does not get into the tool.
Often wipe the car to prevent dust and garbage in the car, which will significantly increase its service life.
Cleaning the output lens:
After the tool was used for a certain period of time, the cleanliness of the surface of the lens should be regularly checked. In the process of processing, pigmenting particles in the fabric enter the crystal,
influencing the laser light stream, which can easily lead to the weak light of the laser. Use paper for lenses or cotton swabs moistened in anhydrous ethanol to gently wipe the crystal. Equipment replacement distilled water
Distilled water must be changed once a quarter. Frequent replacement of distilled water will increase the life of the lamp.
Replacing laser handles
Laser handles have a service life. After the end of the service life, it is recommended to replace a new handle.
